[Shed Hunter]

Hi guys. I just finished building a TM1 (5’x10’). I still have a LOT to learn, so go easy on me! Lol I am waiting for power to the plasma…so I haven’t even ran the table yet. I have some down time to learn about steppers.
My kit came with 2 steppers. One for the X-axis & one for the y-axis. I did not want to put a driveline across the X-axis (dual drive kit). I want to run three steppers. Two for the x-axis, and one for the y-axis.

I am using both of the supplied steppes on the x-axis.

To try and save some money, if it is possible, I would like to use this stepper for the y-axis:

Here are the specs:
KL23H2100-50-4B
Keling technology
Got it here:
Stepper Motor

If this stepper will work, I will need help building a cable (where to purchase the plugs, and what wires go where…?).
I have a quote for a stepper and cable from TM. I can buy it, plug it in, and be done. But man is it expensive! I have already spent a LOT, so if I can save a few bucks here it sure would be nice.
Thanks for your time/help

[agelkom]

Hi,
According to your pdf these wires connect to your stepper driver:
Black to A+
Green to A-
Red to B+
Blue to B-

Can