Did a big mistake and got a short circuit with the screwdriver when i should tighten the terminals on X-axis limit switch...
Have had problems with that the control sometimes does a limit switch alarm when i do fast movement to Y-home. The alarm just stops the control and as soon the alarm comes - it dissapears and i can start the program again but it's very irritating...
Have replaced the wires to the Y-limit switch and checked the switch / terminals and therefore i now was on the X-switch.
However, now the control doesn't work at all and i have parts that should be machined....

The control seems to got into "emergency stop" mode and i couldn't do anything... Have checked every fuse i could find in the cabinet but can't find any bad.

The crt's Operator Message says:
Ex 06 Emergency Stop
Ex 08 Spindle Servo Alarm
Ex 11 2ND Limit Switch is Working
Ex 13 Spindle Oil Air Alarm

On the masterboard there is code "1", that says normal operation.

Have tried with: "disconnect" check soft OT at power on - in IPL mode, but that didn't made any difference.

What should i do to get rid of the alarms? Could something got broken by the short circuit?

Please help....