I am setting up a new machine running Mach3 with a Galil DMC4143 Ethernet Controller.
When the Dwell is set to "ms" in the General Config it only reads in Seconds not ms. (Eg. G4 P1000 dwells for 1000 seconds)

When the Dwell is set to seconds in the General Config and and i set the dwell to .9 sec (Eg. G4 P.9) nothing happens...No dwell at all.

When I set the dwell to 1 second (Eg. G4 P1) it works and dwells for 1 second.

I require a Dwell for less than a second but cannot do it. Can somebody help resolve this.

Mark