Hello,
you cannot run it with factory settings. Factory setting is 50 or 60Hz - but the spindle is designed for 400Hz. You'll need to change this first.
If you have the same VFD as I have this will be:
Parameter 4: 400
Parameter 5: 400
Parameter 3: 400 (needs to be set after 4 and 5)
Parameter 11: 100
(but don't rely on it - you may have a different VFD)
What happens if you run with 50Hz setting is that the spindle will get full voltage and power at 50Hz instead of 400Hz - this is extreme overload - good that the VFD stopped because otherwise the spindle would go up to smoke...
Christian
My CAM Software and CNC Controller: www.estlcam.com