[pinjas]

This name sign was cut for the desk of a person who works with fire! (flame2)
.

Great looking piece with exception to the surface finish. What is the deal with all those loops? Do you eventually buff them out?

[Weldtutor]

What is the deal with all those loops?

Thanks for your interest.

The finishing method used for the above 2 desk names results in a very attractive surface, although it reflects light & will not photograph well at all.

A fine disk is used to polish, followed by adding swirl marks with the edge of a 4" coarse grinding disk.
This is followed by clear or translucent coloured lacquer which enhances the swirl effect.

[Khalid]

Weldtutor..
I am really impressed for the Flame sign... Whenever i saw your new work i am mesmerized..

[Weldtutor]

I am really impressed for the Flame sign...

Thanks for the comment.

I'm pleased that you like the flaming sign!

[adel_sebaey1]

How Can i use a hand torch in (LGK8-100) cut throgh 20mm. in acnc table. pls. any help for that ?

[mo_alhawary]

call me at
0101405249
or
0117080734

mohamed alhawary

[Weldtutor]

Cell will not connect to that #.

[Weldtutor]

Six plus years & this table, with chain drives, continues to produce high quality results. :banana:

Large dolphins are 22" long & smaller ones are 1/2 scale.
Files are modified versions of downloads.

[Khalid]

Thanks God ou are alive again. Nice work as usual? Where were you by the way?

[MecatronicsBoy]

Hello Weldtutor, very very good post, I think I didn't read al the comments, maybe is a subject you talked in some of the comments, but could you tell me wich software coul be used to control the table ?

thanks

[Weldtutor]

Hi MecatronicsBoy,

Welcome to CNC Zone!:wave:

The software used to control the plasma table is MACH 3.

Thanks for your interest.

WT

[tcsibor]

Hello Weldtutor and fellow Canuck. (although I now live in the US) :-) Do the torch plate bearings actually ride on the work?

Thank you
Tom

[Weldtutor]

Hi Tom,

Yes, the transfer bearings on the underside of the torch plate do actually ride on the work surface.
This works quite well & in posts #184 & 281 there is additional information you might find helpful.
Pictures in posts #48, 112, 285, & 363 also show the torch plate & bearings.
The springs on the plate mounting bolts compensate for work surface irregularities.

WT