[robc]

I have a practical cnc 5'x10' table, with height control. The table works great. The only problem i have is that the instructions on how to hook up the height control were not for my hypertherm 900. They send the hook up instructions for a hypertherm 600. Needless to say the diagrams they sent look different than the inside of my 900. Could any of you point me in the right direction?

[redfarm]

the best place I can think of is to goto yahoo.com then to the groups section and search for the plasma cutting group Jim Colt is usually available to help he seems to be very knowledgable as well as very helpful I believe he actually works for hyper therm and should be able to "hook " you up.

http://groups.yahoo.com/group/plasmacutting/

[Rigid Racing]

My hypertherm 1000 manual had a section on where to jumper for voltage outputs. You may want to check yours and see if it is in there.

[aschrine]

I have the hypertherm powermax 600 and I need the switch hook up. Can you please email it to me? Thanks