the acceleration is set lower because im running the machine off a generator!
as its running at my house with no 3 phase.
i have had the machine to 65m/ minute on x and y with same acceleration as original biesse cni control. however while this is fine for point to point machining when using the cv that mach3 offers it is way smoother for engraving and finer work if the acceleration is set a lot lower.(to be fair i never tuned the servos extremely tight as i dont like the oscilations this can cause.
i am using the original dc analogue drives.
i didnt go with kflop due to the huge number of i/o required which i couldnt get with kflop. (ive ordered a kflop for a new project as the backup and help on their forum is superb!)
im just converting another 2 biesse machines using galil rios to give me distributed i/o around the machine
so much to learn, so much to pass on.