I need a post for a osp5000 lathe 2 axis and a 4axis mill post for a p2000 control.
I need a post for a osp5000 lathe 2 axis and a 4axis mill post for a p2000 control.
Ask your reseller for these posts,
- they should be free,
-----and he should be doing a minor customisation to suit your particular machines, AND to have your NC output ( with code & comments etc ) in a layout to suit your shop's needs - this is standard practice,---- if you have maintenance----
The install disks do have posts on them,,,, nothing there ? ....also look for OSP in the filename, not just Okuma
the Fanuc posts are very similar, they only need a few mods,