Dear All
Please let us know various ways of saving power in case of CNC Machines with Fanuc Controlers and Drives.
When just screen is ON, with just a - on drives, what would be the power consumed in this stand by mode
Regards,
M. Rishikesh
Dear All
Please let us know various ways of saving power in case of CNC Machines with Fanuc Controlers and Drives.
When just screen is ON, with just a - on drives, what would be the power consumed in this stand by mode
Regards,
M. Rishikesh
rishikesh Sir,
put a clamp- tester between the earth wire and in a phase together , you will find the reading , Better put a 0.001MFD/1KVA capacitor between all 3 step down phase after isolation transformer . and Two 0.10MFD capacitors / 630V in 24 V and in 110 V circuit it will save the energy due to spikes cycles and irrabit frequencies in case of Idle machine .
Fanuc has standard power rating and saving methods , but the auxillary peripherials Like CT , IT and The 24 V PSU are not made by Fanuc so cycles are not exact as fanuc recommends.
regards
prabhat mishra