Hello, been a long time lurker and have followed the DMM stuff here for a while. Made the decision to go with the system based on the all zone feedback so thank you guys for all of your feedback.

Currently the system i'm putting together is the 4 axis Dyn2/400 watt.
"got the new motors with encoder covers, drive/bob mount...very impressed"

My question is concerning wiring the multiple 48v psu's. This is probably rediculously simple but i dont want to fry something based on my assumptions.

First, can i just run my 110v ac to the first unit, and then chain the input power from that.

Second, can i chain the outputs from first to last, come off of the last straight into bob?

I have done a few searches as well as looked at pictures of some folks enclosures, but i'm still not sure the best approach. Any help would be greatly appreciated.

Also, i spoke to DMM last week and they were very helpful as it took me only 10 minutes to initially tune all 4 drives. I know DMM could likely answer this in 10 seconds but i thought this would be a good oppurtunity to introduce myself.

Thanks in advance
Jake