Hello,

I am trying to set up Mach 3 to work with my control kit and motors. At first I am just trying to get a response from the motors so that I know that things are working.

I have already discovered the problems of having 64 bit windows etc. So I now have a desktop running Windows XP with Mach 3 on it.

I have watched tutorials and it seems that I should be able to configure 'Ports & Pins' followed by 'Motor tuning & setup'. Then, at this point I should be able to get movement from the motors by toggling the up & down keys.

The problem I have is that I do not know what settings to input into the 'Ports & Pins' and the 'Motor tuning & setup' windows. Any help here would be appreciated.

I can find out specific information about the control kit later when I go to the workshop. I bought the control kit from here -link

I have Nema 23 oz motors.

Thanks
Jack