Machine was in mid pgm of drilling cycle when spindle slowed down and stopped. Switched m/c off and tried to restart spindle in pgm mode and no luck, so tried to start spindle in manual mode and still can't get spindle to rotate. Any help would be appreciated.
Results 1 to 2 of 2
-
12-14-2012, 09:56 AM #1
Registered
- Join Date
- Mar 2011
- Posts
- 0
Bridgeport Interact 1 MK 2 Heidenhain 151
-
12-17-2012, 05:07 AM #2
Registered
- Join Date
- Jun 2012
- Posts
- 516
I bet you got f*cked by the MTI-1 board... look at diodes, caps, SCR's, transformers.
Also, simply try to reset the overload (big breaker, also push button on klockner moeller OL).
I've had loads of trouble with the MTI-1 board on my interact 1 mk2. the motor is fine, the FAC1R (and rest of the KTK drive) seem to be good.
If the fuses blew on the MTI-1, its a good bet that something else is toast.
Reply With QuoteSimilar Threads
-
Bridgeport Series 2 Interact 2 Heidenhain TNC 155
By rrossey in forum Bridgeport / Hardinge MillsReplies: 9Last Post: 11-30-2023, 01:10 AM -
Bridgeport Interact 412/Heidenhain TNC 151 HELP?
By larrynsr in forum Bridgeport / Hardinge MillsReplies: 16Last Post: 03-17-2012, 08:21 PM -
Bridgeport Interact 1 MK 2 Heidenhain 151
By tommo61 in forum Bridgeport / Hardinge MillsReplies: 8Last Post: 11-30-2011, 11:35 PM -
Bridgeport Interact 1 - Heidenhain 2500
By nycooh in forum CNC Machining CentersReplies: 2Last Post: 07-26-2009, 10:40 PM -
Bridgeport Interact 1 - Heidenhain 2500
By nycooh in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 06-25-2007, 09:59 AM
Posting Permissions
