[Harish1986]

Hi guys,
Posting for the first time.
We bought a used Fanuc RoboDrill Alpha T14iB (YOM : 2001) but the seller didn't provide any manuals at all and we couldn't start the machine because there a few alarms, which we couldn't correct, Since we don't have the manuals. We couldn't check it either.
If any of you guys can help me out here i would be really grateful.

Can You guys help me out with these Alarm issues.
1. 501: Over Travel : -X
2. 480 : X Axis Illegal Safety Mode (MNT)
3. 487 : Illegal Safety Mode (CNC)
4. 1012 : In the tool change area.
5. 1009 : TCZ Limit switch is defective

Apart from this i have some other issues too. But these are the main ones i couldn't get rid off.

Regards,
Harish

PS: Thanks is in advance.

[SOJI]

Hi Harish
Did you solve problems regarding robodrill

Regards

[mbservice]

Hi Harish
Did you solve problems regarding robodrill

Regards

After 8 years I would have hoped so

[SOJI]

Dear I have just now bought same FANUC ROBO DRILL aT14iB
Facing the issue i have no any detail for pull stud and tool holder
pls help for this.

Regards

After 8 years I would have hoped so