Originally Posted by
bb218
Thanks, I will give it a try. I was trying to enter tools after I had ran part of the job and not from the very beginning, although I would think I could add tools to the tool crib at any time.
When I single click I get a generic tool, If if click on a finish endmill say tool 11 which should be a 3/16 finish mill when it goes into my tool lib it shows .5 diameter I have to edit the parameters to correct them, If I double click the size appears correct but it cannot get it to the tool crib. Same with what ever center drill I pick it single click is always .4375 diameter when I go back to the tool crib, double click shows the correct parameters but will not show up in the tool crib.
Mike