Tried to download a post processor for a new mill that I am getting and on the Bob Cad site this feature is not working.
Tried to download a post processor for a new mill that I am getting and on the Bob Cad site this feature is not working.
Mighty Viper VMC-950, Acromax MX-16, Bridgeport Boss 5, Tongil Panther ST-20, Bridgeport-Romi PowerPath 15, Lagun FTV-2, BobCAD V26,V25, Dolphin V13
Looks like they're re-doing the forum... "By popular demand".
Maybe they'll bring back V21!
I have a few days before the machine gets here, just wanted to start fooling around with the PP (that doesn't sound good).
Mighty Viper VMC-950, Acromax MX-16, Bridgeport Boss 5, Tongil Panther ST-20, Bridgeport-Romi PowerPath 15, Lagun FTV-2, BobCAD V26,V25, Dolphin V13
Maybe mention the post you were interested in here. Someone may already have it on their machine. They dont cost money or anything, so we can pass them around.
I'm looking for the Fanuc 10M post processor. Site is still down.
Mighty Viper VMC-950, Acromax MX-16, Bridgeport Boss 5, Tongil Panther ST-20, Bridgeport-Romi PowerPath 15, Lagun FTV-2, BobCAD V26,V25, Dolphin V13
Here is the V23 Fanuc11M post. If you are only doing 3 axis, there shouldnt be any different for the output. I did a comparison of this and a generic fanuc0 post and there is really no difference. Maybe look at the canned cycles to be customized?
It can be a start, but I dont know the controller and any particular needs. Maybe someone else already has a "10M" setup that will read this...
Here is the 11M for V25.
Thanks guys for all of your help, Ron
Mighty Viper VMC-950, Acromax MX-16, Bridgeport Boss 5, Tongil Panther ST-20, Bridgeport-Romi PowerPath 15, Lagun FTV-2, BobCAD V26,V25, Dolphin V13