hi all please help me here. i m founding the error in tnc 351 control
relay ext dc voltage missing.
shabbir mughal
hi all please help me here. i m founding the error in tnc 351 control
relay ext dc voltage missing.
shabbir mughal
Make sure emergency stop is not pushed in when control is turned on.
Otherwise check 24VDC power supply.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks for reply
i have cleared this error . y hardware limit switch was pressed and creating this error.
but now servo is not turninging on. now i m finding why servo power supply contector is not turrning on?
thanks
shabbir mughal