Hello, Im sorry if this has already been covered, but I am new to CNCzone.com
I have a copy of mastercam X6 Demo and at roughly the 2/3 point I receive this error:
"Error 1330. A file that is required cannot be installed because the cabinet file (D:\x64\data\mastercam x6 demo-hle\data1.cab) has an invalad digital signature. This may indicate that the cabinet file is corrupt. error 266 was returned by WinVerify Trust."
Then shortly after that I receive the same error with this file name
(D:\common\samplefiles\data1.cab)
I have tried to re-install several times and it fails every time. Any info would help. I will check back as much as possible to provide any info needed to help solve this problem.