Damn Moshi board crapped out on me I think.
So I was using Moshidraw 2013 and it works great better than the older crap and I was using it mainly to cut but did some engravings also.
Then today I did 2 cuts, then I did a simple circle to engrave I pressed output and the laser turned on and started going `\` that way so I turned it off so it wouldnt crash.
Turned it back on and the X/Y don't do anything but sit there.
Any output to the machine from the software results from `idle` to `busy` but nothing happens.
Anybody encountered this and fixed the problem besides a new board?