One of our MultiCam 3000 router tables has been showing some strange behavior lately. Occasionally, after pausing the machine during a cut, the machine will stay paused for a random amount of time and suddenly take itself out of pause mode and begin cutting again. This happened again just a moment ago just as I was about to clear a plastic labeling strip which had gotten wrapped around the cutting tool. Luckily my hands were not in contact with the tool when it spun back up.

Also, on rare occasions, the machine will move the gantry from it's parked position to the front of the table with no input from the controller.

Just wondering if anyone with a MultiCam machine has ever experienced this issue or might have an idea where to start troubleshooting it. I have googled this and found no refrences to anything similar.

SB