Hello all, I am trying to get an older Chevalier up and running. It's ran off a Fanuc O-M Controller.
While working with it, I think I maybe have over traveled in two axis so it now has a weird "Not Ready" error.
I have tried the following:
Power down controller and power it back up. Did not work.
Turn off entire CnC and power it back up. Did not work.
Power down controller, and hold "reset" while turning it back on. Did not work.
Someone told me to try holding down "P" and "CAN", power it back up. Did not work.
I used the "Reset Overtravel" to get the X, Y, and Z away from the limits. Then tried all of the above again and still did not work.
Any suggestions?
Thanks.