586,060 active members*
3,566 visitors online*
Register for free
Login

Thread: Fanuc 6T backlash compensation

Results 1 to 3 of 3
  1. 02-17-2013, 04:10 PM #1
    ctroyer
    ctroyer is offline Registered
    Join Date
    Nov 2011
    Posts
    8

    Fanuc 6T backlash compensation

    I've got a Hitachi Seiki 4NE-600 with the Fanuc 6T control. There is about .005 worth of jump when switching from +Z to -Z motion. I'm assuming that the Z backlash # is wrong, but my manual describes the procedures and parameters for the 5T control.
    Anyone know offhand which parameters are for the X and Z backlash?

    Thanks, CT
    Reply With Quote Reply With Quote
  2. 02-17-2013, 09:01 PM #2
    yours_prabhat
    yours_prabhat is offline Banned
    Send a message via MSN to yours_prabhat Send a message via Yahoo to yours_prabhat
    Join Date
    Dec 2008
    Posts
    239
    Parameter 0535 = X axis
    Parameter 0536 = Y axis

    regards
    Prabhat
    [email protected]
    Reply With Quote Reply With Quote
  3. 02-18-2013, 11:31 PM #3
    ctroyer
    ctroyer is offline Registered
    Join Date
    Nov 2011
    Posts
    8
    Thanks, but, sorry - my 1980 6T control runs out of parameters at #0407. (Unless I am failing to enable something in order to see those parameters.) There's nothing like that in the procedure in my manual, though.

    Any other ideas out there?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Backlash compensation
    By lumberjack_jeff in forum LinuxCNC (formerly EMC2)
    Replies: 5
    Last Post: 01-19-2010, 05:15 AM
  2. BackLash Compensation
    By bearracecars in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 0
    Last Post: 05-21-2009, 04:36 AM
  3. EMC Backlash compensation
    By CROSSHATCH in forum LinuxCNC (formerly EMC2)
    Replies: 9
    Last Post: 01-19-2009, 07:30 PM
  4. Backlash Compensation
    By cnccustom in forum Mach Mill
    Replies: 1
    Last Post: 11-22-2007, 02:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules