Hi
I'm having some difficulty figuring out the best way to mold a two sided part. I should add that I'm completely new to this.
This is a large part measuring 950x180x100mm. I'm not sure what shore rating silicone resin to use for this. I'm guessing the 15 Shore A is far too soft for such dimensions?
The main problem though is figuring out how to get the rear side detail into the casting without trapping lots of air or distorting the flat back of the cast part.
I've attached the front and rear views of the part along with the first half of the mold but I would be grateful for suggestions on how to tackle the second half of the mold.
Part Front:
Part Rear:
Mold Part 1:
Many thanks for any suggestions.