Does any one know how to make my ezpath s lathe except a .TXT file off a floppy disk, posted by BobCad. Every time I try the machine says illigal G-code. Thanks
Does any one know how to make my ezpath s lathe except a .TXT file off a floppy disk, posted by BobCad. Every time I try the machine says illigal G-code. Thanks
TXT files are loaded as other files.
Only post that may work would be found in EZCAM and FEATURECAM as Bridgeport was married to them.
Usually a EZPATH is so simple and fast to program that a CAM system is unncessary.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)