Hi guys, I've been reading a lot this forum but sometimes things get confusing
:drowning:

I need to cut and pocket 2 types of Materials
  • Cast Acrylic about 2mm (0.08 inch)
  • Aluminum 1mm (0.04 inch)



I have bought some Chinese 1/8'' Carbide Two Flute Spiral Bit CED 2mm that looked ok to work on these materials and my machine is a Chinese TS4060 H80

I wanted some advice on the usage of these tools on the selected materials
Acrylic IPM, RPM and deep?
Aluminum IPM, RPM and deep?

I've already broken all the tools that were delivered with the machine on tests but i think I need some safe starting points.

Thank you
TC
:cheers: