[Neil28]

Hi, Can anybody help. I need an EdgeCam post for a Deckel DMU 50 eVolution with a Heidenhain TNC426 control. It could be different TNC control I'm sure I could make any alterations on that. I've tried doing a post from a template and am almost there except it won't run the B axis properly. It can't do anything to get around the fact that when you rotate B axis 180 deg, the table actually at 90deg because of the 45deg nutated action. I've modelled the machine up and the graphics work fine if I index to the front face which would be a B+180 C+0 move, but when I post it, it gives me B+90 C+180 because it think B is just rotating around Y and if B when to +180 it would turn the table upside down. Hope somebody can help, EdgeCam haven't been much help so far.

[jtreanor]

I found this by accident the other day,
Its an Edgecam reseller in the Netherlands.

Check with your local edgecam support and
see if they can get a copy of the DMU 50 EVO,
or at least the machine graphics setup / definition.

Machinesimulatie voor frezen, draaien en draaderoderen van Widenhorn: EdgeCAM

[Dam]

Hi Neil,
I need too almost the same postprocessor for EdgeCAM:

DMU 50 evoLinear + HH iTNC530
or
DMU 60 evoLinear + HH iTNC530.

Did you obtain that post??

[jonksey]

Hi
I've DMU 70V