[miljnor]

Well I didn't mean to start another project......

But 20.00 dollars for a bridgeport style casting with table!


Thats too cheap to pass up! Although if you calculate the cost of divorce and loosing half of everything it will probably be worth every penny!

Although going halfsies on my son might be a little over the top.

All joking asside it will be a fun project and I will endevor to get some pictures on by tonight!

:cheers:

[Stevie]

Pics man we need pics

[mxtras]

Nice! We GOTSTA have some piccies, Miljnor. How dare you tease us like this!

Scott

[posix]

posts without pictures should be forbidden!

[miljnor]

I knew that I would catch alot of gaff but Hey I was excited and had to tell someone!

But my camera is at home!

I will take some pictures with my phone just for you guys! But I got to tell you, they are going to suck for resolution!

Edit: I think this was originaly a drill press that is a bridgport look alike! But since so much is gone its hard to tell!

Here they are: Enjoy.

[BobWarfield]

That's gonna keep you busy and off the streets for a while!

Best,

BW

[miljnor]

haven't realy figured out what its final load out will be!

I will sit back and wait for an epiphany!

I got time!

[mxtras]

So - no ideas yet, huh?

It has lots of cool factor, that's for sure! Lots of potential, too I am sure.

Keep us posted, would ya......

Scott

[RotarySMP]

I picked up a Deckel engraver frame in similar condition for €20. I have mounted a Sherline ER-16 spindle on mine and run a 1/2 HP motor with a VFD and four step pulleys (the speed range is about 60-6000RPM) Unfortunately it is located an hour from my apartment

http://www.wrathall.com/Interests/CN...nkenDeckel.htm
I need to update this page with some pictures of it.

The quality of the castings and ways on these old industrial machines is a huge step up from the 7X12 chinese lathe I also have.

[RotarySMP]

Does that table actually have X-Y motion? or just a Z slide?

[miljnor]

Currently it has just a Z-slide.

The reasone that I thought it would be a good base is that the table is faily large. And, of course, Old cast Iron is hard to beat.

I am thinking using the Base plate for bolting linear guides to and then fabricationg the Y-axis slide.

The head has the old box guides still intacked and the look in fair condition. Maybe a good place to bolt some more linear's?

I will have to of course mic out the table Z to see if its anywhere close to square and what not but It should be a fun project.

I am usually a stickler on the mechanical aspects of a job (probably why I am a machinist) but as far a looks and paint It will come no where near the level of your stuff Scott! Your stuff looks good enough to eat off of!