Well, after finally getting the machine set back up after clearing all the memory (by accident, thought I was clearing the tool and fixture offsets - but that's a whole other story). Now I'm getting an "arm must be left" error when I try to enter the MDI. I can do TC,1 and everything works. At a loss.
1996 Fadal VMC15 with 16 ATC
Please help!
Thanks,
Andrew
Thread: "Arm Must Be Left" Error
Results 1 to 3 of 3
-
03-17-2013, 03:12 PM #1
Registered
- Join Date
- Oct 2010
- Posts
- 670
"Arm Must Be Left" Error
-
03-17-2013, 03:41 PM #2
Registered
- Join Date
- Oct 2010
- Posts
- 670
Ran a test on the arm sensors and they are Ohm'ing out showing contact signal.
-
03-17-2013, 04:04 PM #3
Registered
- Join Date
- Oct 2010
- Posts
- 670
Fixed. When I set up the parameters I had told it that I have a pallet changer, which is true, however it is disconnected at this time.....
Off to see if I can get the rest of it back working!
Reply With QuoteSimilar Threads
-
"master encoder state error" AB ultra100 error message
By ShapeShaver in forum Servo Motors / DrivesReplies: 3Last Post: 07-31-2013, 04:09 PM -
Predator Editor not working- "Index Out of Bounds" Error Message?
By cismontguy in forum BobCad-CamReplies: 2Last Post: 02-17-2013, 02:49 PM -
Solidworks files result in "Entity Not Found" Error Messages...
By Pophamrt1 in forum EdgeCamReplies: 6Last Post: 08-15-2011, 09:23 PM -
Mazak T-2 "20 NMI Emergency Stop" Error"
By Jeff_Y in forum Mazak, Mitsubishi, MazatrolReplies: 13Last Post: 01-11-2011, 05:35 PM -
V2XT error message "DRIVE FAULT detected (0,z,y,x) check log"
By rfdoyle in forum Bridgeport / Hardinge MillsReplies: 4Last Post: 10-08-2007, 09:35 PM
Posting Permissions
