I have a Delta 10 installed on a Lagun 310, the Z axis is shot and not feasible for me to repair. I would like the control to ignore the Z axis when referencing and running a program. What eprom parameters need to be changed to accomplish this? I will run my Z axis manually and am aware of the possible ramifications. It would be great if I could acquire a list of the non-supplier parameters that the control uses. Thanks.
Thread: Dynapath Delta 10 parameters
Results 1 to 3 of 3
-
03-20-2013, 01:47 PM #1
Registered
- Join Date
- Mar 2013
- Posts
- 0
Dynapath Delta 10 parameters
-
03-20-2013, 03:24 PM #2
Gold Member
- Join Date
- Feb 2009
- Posts
- 6028
Not sure if you can change that through PIC or if you would need a Eprom change. You should be able to axis inhibit through mode select-set up though.
-
03-20-2013, 04:15 PM #3
Registered
- Join Date
- Mar 2013
- Posts
- 0
Hi UTT,
Thanks for the reply. I tried the axis inhibit but it still needs to referenced before I can run a program. The z drive causes a fault when it goes to reference.
Reply With QuoteSimilar Threads
-
dynapath delta 20
By alex2008 in forum DNC Problems and SolutionsReplies: 6Last Post: 11-09-2011, 11:22 AM -
Dynapath Delta 50
By Nastyzen in forum DynapathReplies: 35Last Post: 07-28-2011, 12:46 AM -
Dynapath Delta 20
By chipman in forum DynaCNCReplies: 0Last Post: 06-14-2011, 01:41 AM -
DynaPath Delta 20
By TowerCNC in forum BobCad-CamReplies: 5Last Post: 03-22-2009, 03:36 PM -
dynapath delta 20
By chipman in forum CNC (Mill / Lathe) Control Software (NC)Replies: 5Last Post: 12-15-2008, 08:47 PM
Posting Permissions
