when i change to a different tool in a tool path operation I don't get updated feeds and speeds that match. Can someone please tell me where the settings are that change this?
Thanks!!!!!
when i change to a different tool in a tool path operation I don't get updated feeds and speeds that match. Can someone please tell me where the settings are that change this?
Thanks!!!!!
dont know if this is what you are looking for but it is in the tool setting page of the ops manager see attached
If you can ENVISION it I can make it
For the later versions of mastercam
- look in the config file, & uncheck the "Lock feeds & speeds" setting .... I think it is in the "Toolpaths" tab
thank did it. Thanks!