Finally after being built out and got my machine in place after 2.5 years, I now have to start up my DahLih with Fanuc 0M.
I is an real beginner in fanuc.
The very first time a test home run XYZ and it works fine. Then I test MDI. It works fine.
Next time I doing the X-home run the speed was a little bit to high. The screen let me now Not Ready but no more as -X override.
Now I try to move the X shaft but don´t find any button. 2 ours later I foun an springswitch outside the cabinet. EMG release.
It works fine and I drive the X-shaft a bit and than home run it. Same with Y and Z. When I realease the spring switch the system wrote same
on the screen Not Ready. I try Reset button with no result. My books don´t tell me what I need to do after this.
About the air. Can the machinery works without air if I don´t need any ATC command. Do I expect any error code?
My test was doing under no air load.
This is to hard to me but maybe simple for you. Do you have time to help me on the way.