[RTI.IT]

Hello!!

I have 2 pcs running identical hardware and versions of Mastercam x6, yet on one machine, and just on the one, lines appear wavy, almost as if sketched by hand when zoomed in. I've checked the PC over and everything is in top shape as far as the hardware is concerned. All drivers are also up to date. I figure there must be a setting in Mastercam that is doing this, but I can't for the life me find it.

Here is sample from the PC in question:

Attachment 181812

Any ideas?

[cadcam]

You have questions on the other forum.

[RTI.IT]

Yes, the same question (but worded differently) is posted on the emastercam forum.

[WallyL7]

You have questions on the other forum.

Yes

NO SOUP FOR YOU!!!!!(chair):nono:

[RTI.IT]

lol, yes, no soup for me. I posted on both forums because I assume different forums will have different users and thus different ideas. Thus far nobody has posted a similar situation / problem on either forum.

[ktdan]

What kind of video card is installed? It looks like you might have some kind of anti-aliasing applied.

[RFB]

RTI.IT,

Check the screen resolution on each of the PCs. I have found that high screen resolution causes the Geometry to be stressed.

RFB