I have been running linuxcnc on my laptop for a about a year now with no issues. I dont have a machine built but I hope to soon if i can sort out my computer issue. Before i was getting latency test results around 4000/5000. A few weeks ago one of the memory modules died on me and i got a 'could not mount' error on boot. I swapped out the memory ran a memory test and no issues.
Now when i run the latency test it runs good for a few minutes then jumps to around 300,000,000. Also it will freeze up for a few a seconds just surfing the net. So far here is what i have tried, nothing has helped
- swapping memory slots
- ran a memory test no problems
- bios hard drive test no problems
- computer is dual boot with XP. XP runs perfectly(games, cad, internet...)
- reinstalled linuxcnc (same problem)
- livecd with linuxcnc (same problem)
Anyone have any ideas what else to try?