Hello,
I just installed version of CamBam 0.9.8L.
It creates the path of the tool center, regardless of compensation G41 and G42.
I tried to post pro Mach3 and Mach3-CV.
How can I do? Thank you.
Hello,
I just installed version of CamBam 0.9.8L.
It creates the path of the tool center, regardless of compensation G41 and G42.
I tried to post pro Mach3 and Mach3-CV.
How can I do? Thank you.
If you are using Profile or Pocket MOPs, CamBam calculates tool path taking the tool diameter into account. If you left the tool diameter at zero in your MOP, CamBam will calculate the tool path on the center of the line/path you have drawn for a Profile MOP. Or, if you used the Engrave MOP, CamBam will calculate the toolpath centered on the line you are engraving.
Don
thank you for this answer.
CamBam does not manages the G41 and G42