Re: IPT 80 Torch question
Originally Posted by
Tallguy64
So found an old thread the Jimcolt replied in and mentioned using a 300 volt relay to isolate the system when cutting. Problem solved there. Just need to know if the tip is actually isolated on the ipt80.
Would you be able to link to that old thread? I have an Everlast with a Trafimet S75 machine torch provided by Everlast Australia with a bare tip. I was going to make an ohmic sensor then got cold feet about the risk of 300 volts flying around...
I don't think your tip is isolated like the Hypertherm torches are. Mine certainly isn't. The HT shield that touches off is isolated from the torch cutting tip.
Rod Webster
www.vehiclemods.net.au