[Al_The_Man]

This is hard to pass up at $10k!!!!!:violin:
150818969793
Al.

[rockcliff]

This is hard to pass up at $10k!!!!!:violin:
150818969793
Al.

Time to dig thru the big pile, I know I have at least two 1030's in there somewhere,

[Al_The_Man]

I have about half a dozen, time to cash in!
Al.

[rockcliff]

it was a great servo card in it’s day, but I think the seller should take a look at his “9” key it must really be sticky

I am laughing and joking now, but what if it really sells

[Al_The_Man]

it was a great servo card in it’s day,

Hey, I am still using them.! :
Al.

[rockcliff]

Hey, I am still using them.! :
Al.

That's very interesting, I should consider applying some power to mine on a future project, I would be curious to see if it even powered up, it's been sitting in a rittal enclosure for at least 10 plus, years

if my memory is correct, I believe the last time I had it running, I was using it with cadtodmc? or cadtogcode? it was some software from galil, it was very limited on the software control end, but I really liked the functions of that card it really can be configured to do anything thru the galil programming language which was perfect for industrial machine motion type stuff,

[Al_The_Man]

The really nice operator interface program they had for it was Opint, I have used it for many projects.
Back gauges, a couple of Cincinnati point to point mills, tube cut off lathe, 3 axis line Punch for a few.
Once you get the hang of it, screens can be made up in short order.
I can also convert the single axis to four!
Al.

[rockcliff]

The really nice operator interface program they had for it was Opint, I have used it for many projects.
Back gauges, a couple of Cincinnati point to point mills, tube cut off lathe, 3 axis line Punch for a few.
Once you get the hang of it, screens can be made up in short order.
I can also convert the single axis to four!
Al.

Nice,

maybe it really is worth worth $10k

[Holzwurm56]

Hi Al_the_man ,

********************************************
Originally Posted by Al_The_Man View Post

The really nice operator interface program they had for it was Opint, I have used it for many projects.
Back gauges, a couple of Cincinnati point to point mills, tube cut off lathe, 3 axis line Punch for a few.
Once you get the hang of it, screens can be made up in short order.
I can also convert the single axis to four!
Al.
*******************************************

I have some DMC-1040 and 1540 and look for a long time for a software . What is Opint , where I can get it ?


Thanks

Hans

[Al_The_Man]

P.M. sent
Al.

[davehall]

The really nice operator interface program they had for it was Opint

Hello Al,

I'm interested in Opint as well, where can I find it thanks?

rgds
Dave Hall

[Al_The_Man]

P.M. sent.
Al.