[carmy]

will love to put my eyse on some text conserning the operation
of that nice fanuc 10m

thanks.

[Al_The_Man]

I don't know of anything aimed specifically at the 10m, There is a couple of books on CNC programming that should cover it, both do examples typically in Fanuc.
COMPUTER NUMERICAL CONTROL PROGRAMMING by Michael Sava & Joseph Puszai published by Prentice Hall.
and COMPUTER NUMERICAL CONTROL by Warren Seames. Published by SME
Otherwise you can usually get the Operator Manual off ebay.
Al.

[BROCD]

CNC PROGRAMMING HANDBOOK By Peter Smid is also very good.

[asuratman]

Hi,
I have roku roku cnc mill with 10M Fanuc. Does this controller have capability for 4 axis? I mean just bought 4th axis cnc rotary table and plug in the controller, then machine is ready for 4 axis operation? Let me know about this. Thanks. Aristo.

[Al_The_Man]

Unless you 10M came with the option already in place then it will be very difficult to implement at this date. If you want to integrate a third party 4 axis rotary table, you would need someone to modify the ladder unless you have an M code set up in a simple fashion to initiate the axis and wait for the finish.
You would not however be able to interpolate another axis with the 4th axis.
Some users have a third party rot. table and use a M00 stop code and allow the operator to start the 4 axis operation.
Al.