Hi everyone.
I have a couple of issues with a post I am making for a Haas ST-30 2 axis lathe. Quite a simple task I thought but I am now struggling a bit!
2 major issues, firstly, the Haas programm manual shows cutter comp being applied within the cycle but in Edgecam under 2 axis cycles, there is no [COMPGCODE] token for me to apply even tho there is a Subroutine & Pathcomp/Controller Offset option under the New Rough Turning tab.
Secondly, and this might be an Edgecam issue, when using New Rough Turning and leaving a finishing allowance on X & Z of different amounts, the post ignores and goes straight to finished size. If however I change to Constant offset, it leaves the stock on for finishing?
I would be very greatful for any help or pointers anyone is able to give.
Thanks
Brian
PS: 2012R2