I posted this on the Tree forum, perhaps here is better.
I have a Tree 325 with a Delta 20 control. The status display shows that Block Delete is off. Is this something that can be toggled on or is it set in the control parameters? Thanks.
I posted this on the Tree forum, perhaps here is better.
I have a Tree 325 with a Delta 20 control. The status display shows that Block Delete is off. Is this something that can be toggled on or is it set in the control parameters? Thanks.
Not familiar with Tree in particular but it can be done by external switch or look on the status screen ( Fault/status key twice) there may be a soft key for block delete and optional stop. If not on this screen there should have been an external switch to turn it off or on.