Dear friends

I have a CNC lathe Mazaktrol T2 using the XZ dual axes (TRA 8). This morning when I turned on the phenomenon appeared:
1. Machine ready OK
2. Home zero OK
3. Rapid X OK
4. Rapid Z OK
5. When I run the Z axis manually close the chuck on the X-axis stand still but when I reversed the Z axis, the X axis automatically advances to 7%
I checked the motor brushes, connectors from the engine to the dual axis but not detect anything unusual
I'm not sure about the dual-axis noise and using physical or situations
Can you guide me on the treatment situation
All your instructions I would like to thank
sorry for my bad English
:drowning::drowning::drowning: