[dirtridn2010]

Hi Guys, I have a PCNC 1100 and have finally had a need to use the scanner so I can reverse engineer a bracket for a mates race car.
My problem is..... I think I have loaded the software incorrectly.

When I activate the scanner and I enter into the "camera settings" I only get half of the screen (compared to what is shown in the PDF file at Tormach).
One of the conditions is that I can turn the LEDS ON or OFF. However that side of the screen doesn't come up...so I cannot turn the light on.
It also does not allow me to save the new conditions (again....on the right side of the screen, and missing).
I uninstalled both lots of software and reinstalled it...but to no avail.
What have I done wrong???
If anybody has some ideas...I am all ears.
(I have the Tormach computer etc. in fact everything is Tormach).

thanks in advance.

Regards

Peter

[BAMCNC.COM]

Screen resolution. Have you tried playing with a higher resolution?