[iceman56]

Hello,

I have a Mazak Slant 40N Universal 1000 with a Matatrol T1. The battery died and the
parameters were lost. Does anyone have these parameters.

Thanks
Jim

[Al_The_Man]

I have some parameters and the definitions for SL-40, maybe not for that particular machine. If you need send a PM with email add.
Al.

[MrMazak]

If you are lucky there is a hard copy of the machine parameters in the electrical cabinet. Some of them are machine specific so inputting just any number will usually lead to more trouble.

[Trill]

Hello Al, im sorry to bother you, i have a mazak Slant turn-15 with mazatrol T-1 control, the machine starts up fine, and moves all the axis, and i can jog the spindle, but im getting an alarm 130 spindle run inhibit, when i try to spindle start, this is the only thing stopping me from puting it to work, i have checked in a thread you have a list of parameters, i was thinking if you still have it, maybe i can compare them to mine, to see if i got somethings wrong, or maybe you have an idea of what its not letting me start the spindle fully, i appreciate your time and atention, thanks a lot.

Trill.

[Al_The_Man]

You will need to PM me an email add.
Al.

[Trill]

You will need to PM me an email add.
Al.

Your inbox is full! [email protected]

[Al_The_Man]

They're sent.
Al.

[Trill]

They're sent.
Al.

Thank you Al!

Hi Al, thank you for the parameters, i have cross referenced them with the ones i have, they seem pretty much the same, do you have any idea why this

130 spindle run inhibit alarm is happening, here is a video if you would like to see it about the machine:

Ver 130 Spindle Rotate Inhibit en YouTube

130 Spindle Rotate Inhibit: http://youtu.be/_jcVV0S3tac

Thanks for your time.

[Al_The_Man]

Check out the spindle motor, brushes and brush gear for carbon build up etc.
Al.