Was hoping someone out there might have some good advice to get my Bridgport Interact with a Heidenhain 151 unstuck. On initialization it is coming up with "Pass Over Z-Reference Mark, Pass Over Y-Reference Mark, and Pass Over X-Reference Mark" all highlighted. Repeated CE, Power Enable, Cycle start, sequences will not cause the axis's to move off their limits.

The drive electronics and axis motion all functioned normally until I got it hung in this state so I believe this isn't a HW problem. I can't seem to find any prescription in the manuals to cover the case where the system is hung in this way - have any of you seen something like this and have some good advice?

Thanks for your consideration,

Mark