Very frequntly Franz kessler motor fails on this machine .and I have option to buy new motor from DMG which I find very very expensive. I have 6RA type Indrament Drive and Indrament motor. i seek help to interface.
regards Chawla
Thread: Spindle Drive of FP5NC BBC Drive
Results 1 to 2 of 2
-
06-02-2013, 04:49 PM #1
Registered
- Join Date
- Jul 2009
- Posts
- 2
Spindle Drive of FP5NC BBC Drive
-
06-10-2013, 09:45 PM #2
Junior Member
- Join Date
- Apr 2002
- Posts
- 5003
I only know 6RA drives from Siemens, they work with DC-Motors. Recently I have slaughtered a CNC-lathe with one of these Drives, but I fear its mach to big for your machine. It runs with 3~400V/63A and drive a 22kW motor.
Reply With QuoteSimilar Threads
-
Going from direct drive to gear-drive? CNC software scaling of steps?
By daffyducky in forum Uncategorised CAD DiscussionReplies: 3Last Post: 11-28-2012, 02:20 AM -
DX32 hard drive (DOM Flash thumb drive) replacement procedures. WIP
By Cellar Dweller in forum Bridgeport / Hardinge MillsReplies: 4Last Post: 01-06-2012, 05:26 AM -
FANUC OT B Spindle rpm fluctuating and causing 1008 Spindle Drive Fault
By Bill Gillen in forum FanucReplies: 4Last Post: 10-15-2010, 07:10 PM -
Direct Drive Plasma - Motor/drive/power supply?
By CPierce18 in forum Waterjet General TopicsReplies: 1Last Post: 02-06-2010, 12:53 AM -
Simple, 3 Axes with Dual Drive/Motor (per axis), hardware splitter drive Interface.
By kreutz in forum Stepper Motors / DrivesReplies: 3Last Post: 07-04-2008, 12:57 AM
Posting Permissions
