[LuciJordan]

Hello from Germany,
We have a Chinese 3-axis portal milling machine with Syntec control EZ-4012-M.
Is not a tool length sensor to this machine.
Has anyone ever mounted on this control a sensor. If so what type and where it should be connected to the controller.

regards

[EXLASer]

Hello,
You had to confirm is there tool sensor program in PLC in CF card ,and if there is ,check I definition as well to make sure which point on I card can connect the end of tool sensor signal.

Then check if you use high level or lower level .
High level :connect the tool sensor signal to the upper end on I card, the lower end connect to 0V ;
Lower level : connect the tool sensor signal to the lower end on I card, the lower end connect to 24V ;

Mary Lee
XYZ Machinery
Attachment 189948