586,094 active members*
3,799 visitors online*
Register for free
Login

Thread: YASNAC MX2 FEEDRATE

Results 1 to 2 of 2
  1. 07-12-2013, 10:21 PM #1
    METCAP
    METCAP is offline Registered
    Join Date
    Jul 2013
    Posts
    4

    YASNAC MX2 FEEDRATE

    I have a Mori Seiki MV 45/40 Mill w/MX2 control. I am needing to program a feedrate less than 1.0. However, the machine will not respond leaving me to dial it back at the control. Does anyone know if there is a parameter to allow programming a lower than 1.0 feedrate, for example (F.75).
    Thanks
    Greg
    Reply With Quote Reply With Quote
  2. 07-14-2013, 12:43 AM #2
    dcoupar
    dcoupar is offline Gold Member
    Send a message via AIM to dcoupar Send a message via MSN to dcoupar
    Join Date
    Mar 2003
    Posts
    2932
    Are programming in inches or mm? Does it actually feed at the programmed federate? (If you program a 1" move at 1 IPM, does it complete the move in 1 minute?)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Yasnac MX2 FEEDRATE
    By METCAP in forum Community Club House
    Replies: 1
    Last Post: 07-15-2013, 05:25 PM
  2. MV 45/40 YASNAC MX2 FEEDRATE
    By METCAP in forum Mori Seiki Mills
    Replies: 0
    Last Post: 07-12-2013, 05:08 PM
  3. Feedrate override vs programming a faster feedrate?
    By Zeppelin1007 in forum Mach Software (ArtSoft software)
    Replies: 2
    Last Post: 01-11-2013, 10:38 PM
  4. Making the transition from Yasnac I80 control to Yasnac J300 control?
    By 56Racing in forum Polls
    Replies: 4
    Last Post: 02-15-2012, 04:52 PM
  5. G02, G03 Feedrate !!!!!
    By usb in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 2
    Last Post: 09-16-2008, 01:19 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules