Hi,
I hope someone can help. I have the following fault come up on my multicam controller after having two problems in quick succession (going too deep too quickly with a bit until the motor drives failed and then moving the gantry when something was in the way which also made the motor drives fail!).
Motor Fault 17
XA
Blink Count 6
RMS Shutdown
Motor torque reqmt too high. Confirm feed OK for bit. Chk for mech bind/drag
exceeded. confirm feed OK for bit. chk for low incomingvoltage.
XB
Blink Count 5
Tracking shutdown
Tracking Limit
What do I do?