[Birkas]

I change the SRAM and initialisation memory A;H . Thereafter software load ( I have only 6/6 floppy for the machine , Backup don't. Power off and on , the machine start with 813 ALARM-P Servo link communication error 20000' S1-1-31'
S-LINK INFORMATION [COND.]-[CH.]-[S.NO]-[ID.NO]-NAME-BOARD
1-1-1-XA-1CB1B105
1-2-3-ZA-1CB1B105

PBU FILE ON LOADING
FIRM WARE FILE ON LOADING
SBP MONITOR
>

Any good idea ?

Thanks .

[Algirdas]

look for orange (optical) cables inside main control cabinet. Careful - these are very fragile. Check them if they connected properly and if they work

[kurmay]

Did you solve this problem?

I change the SRAM and initialisation memory A;H . Thereafter software load ( I have only 6/6 floppy for the machine , Backup don't. Power off and on , the machine start with 813 ALARM-P Servo link communication error 20000' S1-1-31'
S-LINK INFORMATION [COND.]-[CH.]-[S.NO]-[ID.NO]-NAME-BOARD
1-1-1-XA-1CB1B105
1-2-3-ZA-1CB1B105

PBU FILE ON LOADING
FIRM WARE FILE ON LOADING
SBP MONITOR
>

Any good idea ?

Thanks .

[Birkas]

Yes . The MIP 11 Spindle servo control card is bad. We order from GIOCOM SOURCING USA
.

[TYDRAE86]

i have this problem also 813 ALARM-P Servo link communication error 20000' S1-1-31'
S-LINK INFORMATION [COND.]-[CH.]-[S.NO]-[ID.NO]-NAME-BOARD

1-1-5-SA-1CB3V613

[mathiassaid]

Hi Friends
I have okuma OSP 7000 Control
after months of being off now we lit and does not start the boot
I have the diskettes but I need to know how I can
upload this information to the control

Please appreciate if I can help

[OkumaWiz]

Go to electrical cabinet of the machine and turn on load switch. Then press system reset pushbutton. Follow screen prompts for installing software disks. When finished, turn off load switch and press system reset again. Machine should boot, but parameters, etc. will need to be loaded.

Best regards,