looking for a little help on this, a little back ground on the machine, i am following behind someone else who we had set this machine up and programmed the parts. but i am now fine tuning and tweaking the program and parts, so i ASSUMED all the radial and axial tools were setup correctly. So now the issue I have 2 radial tool holders made by hiemetech one has a .122" carbide drill bit and the other has a .1245 reamer. I drill 3 holes on the out side dia, all is good nice and round i come back and ream the holes and it is out of round .005". so i got looking and the reamer was way low so i put a indicator on the ways for the sub spindle, put a gauge pin in the radial head and jog X back and forth and it is out .007" but no matter what i do to adjust the head i cannot get my indicator to read zero.

what am i missing?


Thanks,

Scott