Hi ,
I downloaded the parameters from my Wasino with 10-T controls (in case I goof something up). I saw a lot of symbols flashing across the screen, and wondered if that is what I was supposed to see. Following is a copy of a few lines from the PARAM file that was created on my PC. I have downloaded parameters from my other machines before, and what came out was normal text (ASCII?).
However, the parameters displayed below came from my Wasino lathe with Fanuc 10-T controls after I copied them into Wordpad. Is there a setting I don't know about that will download parameters in normal text? I haven't had to do anything special before.
All this was done with the Program Lock "on".
Thanks,
Bill Gillen
!b4)Q-
5A%
)McJ)Q%S+A%
)qN0)Q%
H)Q%
09Q%
3A%
)MkJ5q$hS=9McJ05-uN+UMcJ05~!N)q%h3T0)UN)cj!N+q s)A%
+qN4)Q%
5Q%)Q%h3-cH)Q%H)Q%
09Q%
3A%
)McJ4+RE)Q$)Q%X)Q%
P)Q%
S)Ag
+QM
)Q%
)Q%^<-RE)QN3Ay$N4+ZO
S+uON<)VVp3A
5+<)RV03A
<+RV3AM
5Q%.S+Ug34)V4+A
4-R4+A3)RE)Q
4+RV3AM
5u/X3AM4-R4X3AM4-R4=3AM
4+RF!cU<+RV3AM
5u?X3AM4)N]3AM
4+4-R433AM4-R4<03AM4-R403AM4-R4<3AM
4+RF!cE<+RV3AM