The Z-axis cogged belt on my circa 1990 Acra knee mill, originally equipped with Anilam Crusader M control, is missing so I don't have the original to get numbers off of.
The aluminum drive housing has the Anilam logo cast into it, so I figure any similar knee mill that has the same should use the same belt. I've already bought new belts for the X and Y axes.
X is a 210L050 56 teeth
Y is a 300L050 80 teeth (There is a mis-marked run of 300L050 by Gates with 84 teeth.)
Z is shorter than the 210L050 but by how much? Tooth profile is the same as the other two.
Results 1 to 3 of 3
-
08-27-2013, 10:20 PM #1
Junior Member
- Join Date
- Apr 2013
- Posts
- 162
I need the belt specs for 1990's Anilam Z-axis drive.
-
09-04-2013, 07:20 PM #2
Registered
- Join Date
- Mar 2011
- Posts
- 67
It is a 187L050 belt. Anilam/Heidenhain P/N 67200057 if they still have it. Try ordering through MSC. They used to deal with Anilam parts.
-
09-04-2013, 07:28 PM #3
Registered
- Join Date
- Mar 2011
- Posts
- 67
If I remember correctly, I think it was a 187L050 belt. A 187L050 is approx 18.7 in outside circumference.
Reply With QuoteSimilar Threads
-
Direct drive axis or belt reduction?
By vertcnc in forum Benchtop MachinesReplies: 9Last Post: 04-19-2013, 11:43 PM -
G0704 z axis belt drive question
By kuyote in forum Benchtop MachinesReplies: 3Last Post: 02-28-2013, 04:55 PM -
Drive Fundamentals : R&P vs belt for 120" router X-axis
By tlharris in forum Linear and Rotary MotionReplies: 4Last Post: 09-11-2011, 04:43 AM -
Thinking about Belt Drive for X and Y axis
By Rob37 in forum Mechanical Calculations/Engineering DesignReplies: 7Last Post: 04-30-2011, 02:45 AM -
Belt drive rotary axis.
By Art Ransom in forum Linear and Rotary MotionReplies: 3Last Post: 07-27-2008, 08:42 PM
Posting Permissions
